Attaching the Snap Assembly with Insulator

The Snap Assembly with Insulator is used to break any electrical connection between the downrigger and the water. This insulator is used with the Short Stop and Positive Ion Control features of the downrigger.CautionDoNotOverloadTheDownrigger.png

  1. Before attaching the Snap Assembly with Insulator, the line must be terminated, see Terminating the Downrigger Line for instructions. The properly terminated line can have a weight attached directly to it.
  2. To begin, make sure that a weight is not attached to the Snap Swivel. Then take the Snap Assembly
    with Insulator and attach it to the Snap Swivel.
  3. The Weight can then be attached to the Snap Assembly with Insulator.

SnapSwivel.pngSnapAssemblyWithWeight.pngNoticeTwoInsulatorsMayBeNeeded.png

Was this article helpful?
14 out of 14 found this helpful

Articles in this section